This kit includes all the formed plastic parts needed to complete the Cartoon Spitfire. The plastic parts makes it easy to build this little plane by eliminating the need to shape the foam sheeting. The included plans have all the patterns needed to cut your foam sheeting with Illustrations and printed instructions to guide you through construction. Step by step instructions are posted on RC groups under foam scratch building or just search cartoon war birds.
Each of the war bird series are equal in size and weight so the power equipment can be interchangeable. Note : The two servos used are inaccessible after construction is complete.
Printed instructions and patterns, forward Turtle deck, Aft Turtle deck , Canopy, Pilot figure, Belly pan, Hatch, cowl, Two spinners and back plates, Two Exhaust stacks, wing scoops , Four rare earth magnets for the hatch.
Wing span.... 28 inches
weight .........11 ounces W/O battery
( add 1 ounce for gear option.)
Materials needed to complete the model :
One foam sheet , 3mm 28 inch X 40 inch
One foam sheet , 6mm 24 inch X 24 inch
Gorilla glue 1 bottle
5 Min. epoxy
1800 KVA Out runner motor
GWS 9x4 prop ( one inch larger than recommended because of the 3 inch spinner)
ESC 10 amp minimum .
Battery 800 to 850 MAH three cell lipoly
KS Steel wire
Main gear P/N 505 . . .17 inches
Aileron torque rods / Tail gear P/N 502 . . .12 inches
Control rods...P/N 501 36 inches
Main gear Dubro 2 1/2 dia.... P/N250 DL
tail wheel 1 inch dia..... P/N 100mw
Axle spacer used Sullivan golden rod P/N 506
control rod guide tubes , Sullivan P/N 507