This kit includes all the formed plastic parts and foam panels needed to complete the Cartoon A-7 corsair. The plastic parts makes it easy to build this little plane by eliminating the need to shape the foam sheeting. The included plans have llustrations and printed instructions to guide you through construction. This model kit has the patterns and parts needed to build the plane in either the Electric ducted fan version or the prop driven version.
Note: this kit is a limited run. When they are gone the short kit will be all that is offered.
The foam wing panels are not cut to net trim. (except for the laser cut wing ribs and leading edge spar) you will still have to cut the panels to the provided patterns.
Kit contains:
Printed instructions and patterns, all the foam panels includeing the sheeting, canopy, wing fairing, Aft Turtle deck , exhaust nozzle, aft belly pan, hatch cover, forward belly pan , duct inlet, radome, inlet duct set, pilot, back plate and spinner and Four rare earth magnets for the hatch.
Specs : EDF
Wing span.... 37 inches
length...........28 inches
weight .........16 ounces W/O battery
Motor . . .2409H-7T 5300 KV
Fan unit....55 mm.
ESC... 35 amp
Specs : prop
Wing span.... 37 inches
length...........28 inches
weight .........114ounces W/O battery
1800 KVA Out runner motor
GWS 8x4 prop
ESC 10 amp minimum .
Battery 1600 MAH three cell lipoly
Materials needed to complete the airframe.
Two foam sheets , 3mm 28 inch X 40 inch
One foam sheet , 6mm 24 inch X 24 inch
Gorilla glue 1 bottle
5 Min. epoxy